Flex Angle Boot

Kabellab LabPatch-FO flex angle boots for SC and LC fiber optic connectors are available on any single-mode or multimode patch cord. They are designed so the installer can pre-bend the boot into any direction or angle. This position is maintained for optimal network performance but, can be reshaped at any time or straightened for connector disconnect. This enables perfect installation of the connector in unique applications such as, tight constraint areas or  high density environments. These fiber optic patch cords with LC flex boots are ideal for cable management situations where additional fiber bend protection is desired.

KABELLAB’s new 2.0mm and 3.0mm boot addition for the Premium SC connectors. The Flex-Angle boot is designed to bend and maintain any angle or direction from straight to 90°. The boot is molded over a single stainless steel wire and can be easily positioned by hand. The internal wire holds the boot at the desired angle or direction.

Flex Angle Boots is solving the congestion problems that naturally occur when hundreds of fiber terminate at one small patch panel. Flex Angle Boot is designed for installers and technicians can be “pre-bend” the boot to any desirable angle needed.